Top Navigation

UTV Hitchworks – RTV-X Hydraulic Conversion Kit Installation

 Free-Report-Banner_01



UTVHitchworks.com – Welcome to UTV Hitchworks, Home of the Farmboy. In this video we will be demonstrating the proper installation of the RTV-X Hydraulic Conversion Kit. This kit attaches to any Kubota RTV-X900, X1100, X1120. The first step is to raise the dump bed. Be sure to follow all proper safety procedures with the dump bed raised. Put the dump bed lever into the float position. This is when the handle is all the way down – it will stay in place when the float position is achieved. Disconnect the hydraulic lines from the dump bed cylinder, leaving the 90 degree fittings connected to the dump bed cylinder. Route the disconnected lines to the rear of the vehicle. The line marked with yellow will need to have the orientation of the 90 degree fitting attached to the supply changed. This fitting must be removed and reinstalled so that the fitting faces the axle. Connect the lines to the back of the provided bracket. Make sure to line up matching colors. Once the lines are hand tightened, use an 11/16” wrench to tighten the fittings an additional quarter turn. Next, align the bracket with the 2 factory holes as shown in the video. Make sure the quick couplers are facing out. Then, install the provided hydraulic lines on the dump bed cylinder. The line marked with yellow goes to the bottom of the cylinder. The line marked with white goes to the top of the cylinder. The completed installation of the Conversion Kit should look like this. For more information on the Conversion Kit, or any of our other products, please visit www.utvhitchworks.com

No comments yet.

Leave a Reply

Powered by WordPress. Designed by Woo Themes